Mattress: Matterhorn DualFirm
RV Model: Landmark 365
Here are a few photos of our RV bed platform prior to bringing the new beds in.
Note that I made a few changes:
1. I adjusted the position of the night stand tops so that they would not overhang to beds and impede their articulation.
2. I replaced the bed platform wood to be sure the adjustable bed side rails were fully supported. The OEM used a queen sized platform then used a king mattress with a heavy steel wire sewn into the piping all our the perimeter of the bottom of the mattress. The wire provided support even though the mattress overhung the platform.
3. Note the photo showing the platform opened on its hinge. There is a compartment behind the drawers which would be sacrificed if that platform cannot be opened via the hinge. I cut openings at each side of the compartment so that small, flexible items can still be stored thereby not sacrificing the space in its entirety.
4. I replaced the hydraulic lift arms with heavier capacity arms in the event that the space under the bed absolutely had to be accessed and bed and bedding had to be lifted. With the new beds in place, it’s very difficult but can likely be done by two people.