AXEL BLOOM ADJUSTABLE BED FOR 2022 TIFFIN ALLEGRO RED 33AL

Adjustable Bed:  Custom King Doppelflex MX2 TWO-MOTOR ADJUSTABLE SYSTEM (35.5″ x 77.5″ – Custom RV Dimensions). Two independently operated beds.

One adjustable bed had a special modification at the foot section to allow the door to the laundry to open without interference. See below for photos.

To lift platform for storage access, cut back external frame 28.5 inches. (Platform hinge location is 28 inches from headboard). This results in 48 inch section of the lower external frame available to be screwed onto platform using four L-shape brackets for each adjustable bed.  This platform (with the adjustable beds and mattresses) can then be raised normally to access the storage area.

Mattress Model: DW 800 Medium-Firm to the Comfy Mattress. Each mattress 35.5 x 76 inches with one mattress custom curved at the foot.

RV Model:Tiffin Allegro Red

Customers: Dan and Carrie Goesen

Location: La Mirada, CA.

 

Placed two adjustable beds on platform. Notice the left bed as a special notch back at the left side where it faces a side door for access to the laundry machine. To allow for the door opening,we specially cut and made a custom section and mattress to accommodate it.

The notched-in mattress corner resting on the custom adjustable foot section.

Removing the slats so we can make a hope in the platform to drop down the transformer cables into the storage compartment.

The transformers are located here and then connected to an extension cord which is connected to one of the two available 120 V outlets on each side of the bed.

The platform is raised to allow us to work beneath to connect the power cables.

Note that the side stopper at the head is away from grazing the side table and window valence.

This is the special notch-in foot side of the platform that is beside the door access to the laundry machine. Raised for us to complete the installation.

Raising the foot section of one bed.

Screwing on the foot stopper.

Notice we have already attached the four side stoppers to the head and foot locations to prevent the two mattresses from sliding off.

Brought in the slider to make sure we did not interfere with the drawers and handles. We actually had to swap the door at the far end with another door above it that had a handle that missed the edge of the adjustable bed. The other foot drawer was 1 mm from the foot stopper! You can see it in the photo. Nailed the length!

Location of two transformers for the motors. They connect with an extension cord which is connected to a 120 V outlet.

Job Completed!

And here are Carrie and Dan! Big Smiles!

View along the corridor with slider extended. Plenty of walk way room. Door at far end opens into the laundry machine.

Another view of the corridor and how to start lifting the platform to access the storage compartment.