RV Adjustable bed: Custom King Doppelflex MX2
Two independently operated 2 – motor custom Half – King Adjustable system ( 35.5 X 77.5 inch) screwed on platform in four places with L-shape brackets. Piano hinge to lift platform to access storage is 29 inches from the headboard. To continue to access the storage compartment, cut the external frame 29.5 inches from the back of the adjustable bed. The remaining external frame is screwed on the lower platform with four L-shape brackets for each adjustable bed that are pre – installed. This allows the lower platform to be lifted up, as per normal, to access the storage area, without the whole adjustable bed being lifted off the platform.For further information, click here: https://luxuryrv.axelbloom.com/pages/rv-installation-guide-for-adjustable-beds
In addition, both adjustable beds have Default setup that allows the head to raise up first without moving the lumbar/shoulder). Side sleepers love it but some people with GERD/Acid reflux , prefer to sleep on their backs and do not like the head to be tipped forward. The ‘Straight Back ” option addresses that desire for a flat head/back motion.
RV Mattress model: Two DW 800 mattress medium firm to the comfy. each 36 x 79 inches
RV Model: 2018 Newmar Ventana 2407
Location: Lenoir City, TN
Customer: Thomas and Teresa Cooper
Used existing hole to snake through power extension cord to connect to existing 120 volt outlet in lower compartment.
Just enough (1.5 inch) clearance between edge of platform and side table.
Same clearance (1.5 inch) from side table to edge of platform.
Both adjustable beds screwed down on platform. One section raised to show flexibility of the lower section.
You can see how the lower section can be flipped back like a double-jointed structure.
View of the two adjustable beds with the air gap between them about 1 inch for wiggle room during installation and to prevent the beds from rubbing against each other in the center.
The adjustable bed frame is flush with the edge of the platform and 1.5 inch away from the side table.
The other adjustable bed in the flat position and again with 1.5 inch air gap between the side of the adjustable bed and the side table to allow the side stopper to avoid grazing the side table.
View before sliding in the platform. Note the location of the lower side stopper.
We are slowly sliding inwards the adjustable bed to check that when it is fully slid in, that it will not touch the cabinets.
The foot stopper is screwed on correctly. Does not hit the stone table top.
Mattress stops just at the stone table top.
Lower adjustable bed does not touch cabinet.
Raising the platform to access storage area.
Platform fully raised using existing strut.
Another view of the raised platform.
Teresa raising and lowering the platform by herself.
Finally, enjoying a well deserved rest!