Adjustable Bed: Custom King Doppelflex MX2 TWO-MOTOR ADJUSTABLE SYSTEM (27″ x 76″ – Custom RV Dimensions). Two independently operated beds.
One adjustable bed had a special modification at the foot section to make it easier to navigate the corner to get into bed. See below for photos.
To lift platform for storage access, cut back external frame 28.5 inches. (Platform hinge location is 28 inches from headboard). This results in 48 inch section of the lower external frame available to be screwed onto platform using four L-shape brackets for each adjustable bed. This platform (with the adjustable beds and mattresses) can then be raised normally to access the storage area.
Mattress Model: DW 800 Medium-Firm to the Comfy Mattress. Each mattress 27 x 76 inches with one mattress custom curved at the foot.
RV Model:Tiffin Allegro Breeze 31BR
Customers: Mark and Kris Katsikaris
Location: Yucaipa, CA.
Have a wonderful trip to Missouri Mark and Kris!
Yong
Located power supply in rear section of the storage area by removing panel. To hook up the two transformers (white boxes) for the two adjustable beds, used an extension cord with two outlets.
Struts did not require replacement. Customer might get a stick to keep platform up when he accesses the storage area. For now, he is able alone to raise the platform normally.
Both transformers hooked up and strapped together.
Both adjustable beds placed side by side. Just checking placement. We ended up setting them a tad away (about 1.5 inch) from each other as we observed that the side stoppers near the head region were adequately away from the window valences (see top left of the side stopper position).
The left adjustable bed was specially made to achieve a notched corner to make it easier to enter the bed from the side. Note that there are three black plastic feet that swing freely from the underside of the foot section. These cup feet are placed on the black rods were there is white silicon grease.
Screwing down the adjustable bed onto the platform.
There are six L-brackets that are screwed onto the platform for the left (notched in) adjustable bed. And four brackets for the right adjustable bed.
We made the two adjustable beds narrower to ensure the side stoppers would not graze the window valence and side table.
You can see how our lower section can curl over to make it simple to locate the L-brackets to screw on the platform.
Overall view of the adjustable beds.
Job complete! The adjustable bed and platform are lifted normally.
Adjustable bed raised. The back is partially raised; the foot is fully up. Independently operated and with wireless controllers that have three memory settings each.
Note that the final height of the adjustable is higher when the 7.5 inch thick mattresses are placed on the bed.
Location of the control box/receiver. There is a button on the box for emergency lowering of the bed in case the wireless controller fails or is lost! There is a USB input on the box for charging phones etc.
Bed is brought in so make sure the foot stopper will not graze the drawers or handles.
Lots of space when the slider is moved out. The curved customer mattress can be seen in the mirror.
Kris is already napping! Mark was uncertain if the narrower custom half -Queen would be small for him but he is comfortable.
Another view of the layout of the bed.
Simply Beautiful!
We installed the adjustable beds in 2 hours.